How To Staple Paper To A Roof

Working with a helper unroll the paper so it is about 2 inches below the sill plate and pull it taut.

How to staple paper to a roof.

Roll out and smooth the wsu and drive a few nails on one side to hold it temporarily. Tack it to roof using a hammer stapler or an electric staple gun. How to install roofing tar paper. Measure the width and height of each section separately.

Measure the size of your roof in square feet. The overhang to the next strip should be 3 8 inch. When you arrive at the rake the paper should be cut flush with a knife and then adjusted to line up with the chalk line. Unroll paper if you will be attaching the building paper with cap nails use a chalkline to mark the sheathing with the locations of studs.

All nails and staples should be placed on the lower half of the paper. Roll out the first section of tar paper over the ice and water shield. Snap chalklines on both sides for guides. Step 5 overlap the next strip of tar paper over the first one by 5 inches and staple in place.

Press into place remove the nails and peel off the paper on the other side. The idea is to make sure water that falls on the roof drips down from paper to paper and off the roof rather than up under the tar paper potentially damaging the roof s wooden structure. Check that it is level and aligned and drive staples or cap nails. Fold over the other side and peel off the paper backing.

Use a ladder to reach the bottom level of the roof. The paper should then be nailed in or stapled every three to four inches across. Multiply the width by the height for the.