A light touch is all it needs.
How to treat wood siding next to deck.
Following this the wood needs to fully air dry.
Once the wood is dry it s safe to treat the wood or at least begin the additional steps.
Your oiled siding will look so good that you won t believe you did it yourself.
The board on your deck that is attached to your home is called the ledger board.
Some options to treat untreated wood are wood oils top coatings sealers and stain sealant combo products.
Be sure to use safety glasses.
For best results the stain should be applied within 48 hours of the bleach treatment.
While standing on the ground or on a ladder next to the deck use a claw hammer or pry bar to remove rotten wood deck boards.
They may be great for boats that have teak wood and such but not so much for your deck.
But when applying the oils a light touch is what you need.
Step 2 sand the entire surface of the wood along the grain with a sander and 250 grit sandpaper to make it smooth.
At this point you can apply a fresh coat of oil or oil stain.
Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.
It is this board that on every deck i have inspected is improperly installed flashed.
There are different wood sealing options for outdoor use but the best choice is often related to the specific project.
Ipe wood throws the excess oil right back at you.
If your house has siding that siding must be cut away and the area must be flashed properly before the ledger board is attached to the house.
Hand sand corners edges and other areas difficult to reach with the sander.
The easiest way how to treat untreated wood for outdoor use is to apply a wood sealer.
Then slip flashing behind the siding covering the top edge of the ledger.
Wash the wood with soap and water and allow it to dry completely.
Step 1 treat with a bleach solution since white pine the wood selected for the exterior logs has a tendency to grow mold the exterior logs were prepped with a bleach solution before staining.
Start by making an outline on the siding where you want to position the ledger board.
You most certainly need to use penetrating oils to help the wood keep that dark color.
If your home has wood siding examine the siding around and beneath the windows for signs of swelling or discoloration.
After intact sections are removed turn the boards over and pound out the nails from the back.
To do so start by cleaning the wood and drying up the remaining water.
Don t use film forming coatings.
Snap a chalk line cut out the siding and tack up the ledger board.
Pry off as many of the intact sections as possible.