Installing Glass In Cabinet Doors With Silicone

Run a bead of silicone around the inside edge of the.

Installing glass in cabinet doors with silicone.

Insert and center your bendheim decorative cabinet glass in the door opening. You will see a channel cut into the perimeter of the opening. Two of my upper cabinet doors needed glass which was just installed with silicone a few minutes ago and they are perfect. Use the ball end of the glass cutter to break the.

If it doesn t fit flat scrape and smooth the channel with a chisel until the. With the door set flat apply small drops of silicone caulking to the four corners of the opening as well as approx. Add a bead of silicone along the inside edge on the front side of the cabinet door. Set the glass panel in place in the recess.

Cut the tip off a tube of. Place the new glass in the channel. Carefully measure each opening and subtract. Apply a small bead of clear silicone on the lip of the panel recess at the back of the door.

Carefully insert lexan glass into frame pressing the glass firmly into the frame. Insert glass and reassemble. Apply silicone caulk to the inside perimeter of the door frame or screw in glass clips no farther than 12 inches apart. Using a glass cutter and straight edge cut the glass to size.

Clean the area where you will install the new glass. Watch weekend workbench sundays at 11am o. Drop the glass plexi in place on top. Installing glass in a cabinet 1.

Every 6 inches along the sides. Wipe any excess silicone off the face of the glass and allow the silicone to dry. For glass you will need a silicone for glass as the one i purchased specified plastic. The installer put a few pieces of blue tape on the glass door until the silicone dries and said to remove the tape tomorrow.

Avoid using too much silicone as it may squeeze out onto the front of the door. Remove cabinet doors and lay them face down on a protective surface. Hang the cabinet doors using the hardware removed in the first step of the process. 2 apply a small bead of clear silicone along the outer edges.

You cannot see the silicone and he did not need to take the doors off. Any excess will have to be removed later. Who knows what the difference is.