Take your measuring tape and measure the height of the door opening from the threshold to the bottom of the drip cap.
Installing screen panel into storm door.
The splines are pieces of narrow rubber tubing that keep the screen secure around the door frame.
Step 3 remove window panes.
Pick a flat area near the entry door lay the box flat on the ground fold it open and check to make sure you have all the parts.
This is not an instructional video.
Install the handle set and associated hardware of the new door lock.
Slide the expander off the bottom of the door and install the sweep.
Window screen hanger latches finish mill stamped aluminum used to install 7 16 inches window screens to wood framed windows will install 2 window screens.
Pull the splines out of the door frame groove with steady firm pressure.
Use an awl or your screwdriver to pry up the spline at the corner of the frame.
It should not go in between the screen and the door frame.
Complete the installation by installing the door closer.
Start at the top of the door and hold the retainer at about a 45 degree angle with the edge with writing on it facing you.
Slide it into the door channel in front of the screen.
If you chose to install a new window the process is very straightforward.
Working your way down the door slide and snap the retainer into the track until the markings are no longer visible applying pressure as you go.
Use this measurement to mark the appropriate point on the hinge side z bar with a pencil then use your hacksaw to cut.
Screw the bolts back into the door and you are finished.
Begin the project by folding open the box and removing the glass storm panel.
Set it and the screen panel in a safe place out of the wind.
It is intended to give you a good idea of the steps involved when installing an emoc storm and screen door.
There is a separate piece of spline for each side of the screen.
Get installation instructions for your storm door including preparing the rough opening sealing shimming fastening flashing and water management.
Use a nut driver or a screwdriver if needed and unscrew the window that is currently on the storm door.
Insert the retainer strips in place.
Remove the glass and place the screen in the door opening.