Glazed window pane is now ready for paint.
Installing window pane in door.
Carefully lay the glass in place add another bead of caulk around the inside of the glass and frame around the hole on the other side with the decorative moulding.
Finish the corners with a handsaw.
Use a heat gun to soften old glaze.
Although glazing putty is the best choice for installing a pane of glass you can use latex caulk.
Place it across two sawhorses.
Place another sawhorse under the location where the door will be.
Http bit ly 1hmtbbx watch more mr.
Scrape excess glazing compound from window pane.
Retract the finger pulls and push the insert through the notch.
Remove the door from the hinges using a drill driver.
How to put a window in a solid wood door step 1.
Caulk is easier to use than putty but it will shrink which can loosen the glass and it won t.
Press the new window glass lightly to bed it.
If you are installing glass in a door i would strongly recommend getting a piece that is to 3 8 thick and tempered tempered glass is about 4x stronger than plain glass and if shattered it breaks into a bunch of tiny relatively harmless pieces vs.
Press in new glazing points every 10 inches with the tip of a putty knife.
Use a caulking gun and squeeze a thin layer of window glazing compound in the primed grooves.
Apply glazing compound with a putty knife.
For the top window insert the top corners into the track and lower the insert line up to the finger pull with the notch on the frame.
If any voids show under the glass pull out the pane add more putty and start over.
You can then scrape old glaze off with a painters knife.
Wiggle the pane into the putty while applying even pressure with the tips of your fingers.
Place one clamp on the door at each sawhorse.
How to glaze a window pane.
With the help of a friend set the new window glass in place.
The super sharp shards of regular glass.
Cut the panel out of the door or a piece the size you require for your window.
Continue pushing down until the glass is centered in the opening and about 1 8 inch of putty remains between the face of the glass and the rabbet.
Once one side is secured flip the door over and lay a bead of caulk around the inside of the moulding.
Coat the exposed raw wood with paint.
Sand the edges of the opening with medium grit sandpaper to make it smooth.