Instructions For Installing Self Closing Door Hinges

Installing a self closing hinge first place the hinges onto the door.

Instructions for installing self closing door hinges.

Before you begin installing your pocket door read the directions for the pocket door kit you re installing to get an overview of the process and what s involved. These hinges have sealed pins that cannot be removed these hinges swing easily last for years and are good for heavy doors. Make sure the soft close hinge is squarely in place and flush with the top of the cabinet door. Then remove the pin using pliers.

Close the door and adjust the tension. Open the door that you wish to install the new hinges to. Step 1 remove the old hinges the current hinges on the door have to be removed in order for the new self closing door hinges to be installed. Loewen door installation guide wood framing 16 installation instructions securing door assembly hinges continued the screws will be driven through the frame shims and secure the hinge assembly to the frame studs.

Insert a locking pin. Once it is aligned properly you can fasten it into place. Check out other cool stuff from ideal security in. All pocket door systems are installed in basically the same way but the manufacturer s directions should give you the.

Using a hex wrench open the spring so you can see the tension pin. If the holes align you can simply attach the hinge using the screws it came with. The home mender shows us how to install a hinge pin door closer. See if they line up with the nail indents from the previous hinges.

If your spring hinges feature a hex opening on top of the barrel insert an allen wrench and turn it clockwise to increase tension. Types of door hinges. Once the spring is removed you can take the other screws out and remove the hinge normally. Use the screwdriver to remove the screws from the top hinge that is connected to the frame and do the same with the bottom hinge.

If the rubber mallet doesn t do the trick then the hole is probably not drilled properly. Shut all your doors without even trying. Ensure screws are not over tightened to avoid a gap at latch side or in the centre of the 2 panel doors. You can then remove the hex wrench and allow the spring to naturally unwind.